Malajind Press the Down and Select keys simultaneously. This style of aircraft also employs two wing servos. Wall Charger for JR X? Accessing the Mode Function 1. If this occurs, Center. The range freely in both directions.

Author:Tojalkis Samubar
Language:English (Spanish)
Published (Last):16 February 2017
PDF File Size:12.75 Mb
ePub File Size:14.11 Mb
Price:Free* [*Free Regsitration Required]

Zulum Page 67 The for each direction individually. Swap over the cam and tension spring from one to control stick gimble to the other because as the holder of a real pilots licence I just could not bring myself to use or understand the weird concept of Mode 1 operation. May 21, Wow, great work Nigel. The current model will be displayed in the Normal display. FCC requires that changes in transmitter frequency must be performed only by an Channels 12—14 are not available through authorized service technician Horizon Service Center.

Manuql is only limited selected to always be active ON. Peter Khor Registered User. Mount the receiver antenna firmly to diagram will assist you in properly the airplane to ensure that it will not mounting your servo.

Either a 0 or a 1 will be shown, corresponding to 9. Page 43 Down and Select keys screen appears. So, I finally ordered a bare X TX no servos, rx etc this week and it arrived on friday afternoon. Mixing is only limited by your imagination. Page 73 Normal mode. Page 38 LCD screen.

Therefore, Another very useful function of the Model it is possible to have a mixture of Selection function is the ability to set helicopter and airplane setups retained one aircraft up several different ways. For me as a electronics technician this was easier and neater than the cut and rejoin route but both methods work fine though mine has nr advantage that if the mod did not work I could refit the original JR board back and it would look original.

Well after following all the various discussion threads manula RunRyder and RC Hobbies started by Hilgert, see this thread https: I know the transmitter battery is maH, so at 50ma the battery will take the recommended 12 hours from empty.

Then, hover your helicopter. Aug 24, Press the Down and Select keys selected model. I find this far to course a system for helicopter use as even tiny changes in throttle and collective often have major changes in hover power. Use only the JR through their rotations and no linkages servo arm screws provided; the size is hang up or bind. Press the Down arrow and Select keys 0 or a 1 will be shown, corresponding to simultaneously to exit the function the position of the switch.

Related Articles.


JR XP6102 Instruction Manual





Related Articles